# Cisco ENARSI 300-410 practice exams

> 300-410 practice exams: 290 questions in 5 timed tests covering Layer 3 Technologies. Every answer explained, with a score for each domain.

Page: https://devopscodelab.com/exams/cisco-300-410/

290 questions in 5 timed practice tests. Each test has about 60 questions and a 90-minute limit. The pass mark is 80%. Results are split across the 4 exam domains.

## Exam at a glance

| Setting | Value |
| --- | --- |
| Practice tests | 5 |
| Questions in total | 290 |
| Questions per test | About 60 |
| Time limit per test | 90 minutes |
| Pass mark | 80% |
| Question types | Single answer and multiple answer (29 multiple-answer questions) |
| Level | Professional |
| Category | Networking |

These are the settings of our practice tests. Check the official Cisco exam page for the current format before you book.

## Domains and weights

| Domain | Weight | Questions in our bank |
| --- | --- | --- |
| Layer 3 Technologies | 35% | 101 |
| VPN Technologies | 20% | 58 |
| Infrastructure Security | 20% | 58 |
| Infrastructure Services | 25% | 73 |

## Price and access

- 300-410 practice exams: $14.99 for 12 months of access.
- Free mini exam: 15 questions with explanations (free account): https://devopscodelab.com/app/exams/cisco-300-410/mini/
- All-Access subscription includes every exam: https://devopscodelab.com/pricing/
- 10 free questions with answers: https://devopscodelab.com/exams/cisco-300-410/free-practice-questions/

## Sample questions

### Question 1 of 3

A BGP session to an eBGP peer stays in the Active state. The peer's address is reachable with ping, and the remote AS number is correct. Which issue is MOST consistent with this state?

- A. The session is established but the maximum-prefix limit has been exceeded
- B. The peer has received the session but the routes are rejected by an inbound prefix list
- C. TCP port 179 cannot connect, for example because update-source does not match
- D. The BGP router IDs on both peers are identical, so the UPDATE messages are rejected

**Answer:** C

**Explanation:** Active means the router is still trying to open the TCP connection to port 179, which commonly fails when the source address does not match the neighbor statement on the peer or when an ACL blocks TCP 179. A prefix list rejecting routes would occur on an established session. A maximum-prefix violation tears down an established session and shows Idle (PfxCt), and a duplicate router ID is detected after the OPEN exchange rather than leaving the session in Active.

### Question 2 of 3

In a hub-and-spoke design where the hub uses a single multipoint GRE interface, EIGRP routes learned from spoke A are not advertised from the hub to spoke B. Which change on the hub tunnel interface corrects this?

- A. no ip next-hop-self eigrp 100
- B. no ip split-horizon eigrp 100
- C. ip bandwidth-percent eigrp 100 75
- D. ip summary-address eigrp 100 0.0.0.0 0.0.0.0

**Answer:** B

**Explanation:** EIGRP split horizon prevents the hub from advertising a route out of the same interface on which it was learned, which blocks spoke-to-spoke propagation on a multipoint interface; disabling it fixes this. Advertising a default summary would give the spokes reachability but replaces the specific routes. Disabling next-hop-self changes the advertised next hop but does not allow the routes out, and bandwidth-percent only limits EIGRP control traffic.

### Question 3 of 3

A branch router learns its default route from headquarters as an OSPF external route. A 4G backup router is reachable at 192.0.2.1, and the static default route toward it must be used only when the OSPF default disappears. Which command meets this requirement?

- A. ip route 0.0.0.0 0.0.0.0 192.0.2.1 permanent
- B. ip route 0.0.0.0 0.0.0.0 192.0.2.1 120
- C. ip route 0.0.0.0 0.0.0.0 192.0.2.1 110 tag 5
- D. ip route 0.0.0.0 0.0.0.0 192.0.2.1 100

**Answer:** B

**Explanation:** A floating static route needs an administrative distance higher than the OSPF route it backs up (110), so a distance of 120 keeps it out of the routing table until the OSPF default is withdrawn. A distance of 100 would beat OSPF and take over immediately. The permanent keyword keeps the route installed with the default distance of 1, which also overrides OSPF, and a distance equal to OSPF's 110 does not reliably prefer the OSPF route.


## Study plans

### Two weeks

1. Day 1: take practice test 1 in exam mode to get a baseline.
2. Days 2 to 5: domain mode on Layer 3 Technologies and Infrastructure Services, the two most heavily weighted domains.
3. Day 6: practice test 2 in exam mode, then the mistakes quiz.
4. Days 7 to 12: practice tests 3 to 5, one every other day, each followed by its mistakes quiz.
5. Days 13 and 14: final mode. Book the exam when your readiness stays above the pass mark.

### Four weeks

1. Week 1: one practice test in practice mode, reading every explanation. Note your two lowest domains.
2. Week 2: domain mode on those two domains, then a second practice test in exam mode.
3. Week 3: practice tests 3 and 4 in exam mode, with the mistakes and flagged quizzes after each.
4. Week 4: practice test 5 and final mode until your readiness holds above the pass mark.

## Questions about the 300-410 practice exams

**Are these real 300-410 exam questions?**

No. We write every question ourselves and map it to the published 300-410 exam objectives. We do not use leaked or recalled questions.

**Do the time limit and pass mark match the official exam?**

They match the settings of our practice tests. Exam providers change their format from time to time, so check the official exam page before you book.

**Can I try it before I pay?**

Yes. The free mini exam has 15 questions with full explanations and needs no account.

**How long do I keep access?**

A single-exam purchase gives you 12 months of access. All-Access includes this exam for as long as your subscription runs.

**What happens after I finish a test?**

You get a score, a pass or fail against the pass mark, a score per domain and every answer with its explanation.

Last updated November 2026.

DevOpsCode Lab is not affiliated with Cisco. 300-410 and related names are trademarks of their owners. We write every question ourselves; these are not real exam questions.
