# Free 300-415 practice questions

> 10 free 300-415 practice questions with the correct answer and an explanation.

Page: https://devopscodelab.com/exams/cisco-300-415/free-practice-questions/
Practice exams: https://devopscodelab.com/exams/cisco-300-415/

### Question 1 of 10

A new branch WAN Edge router powers up and must learn which SD-WAN Controllers and which SD-WAN Manager it should connect to. Which component performs this initial authentication and hands out the controller information?

- A. SD-WAN Controller, which acts as the OMP route reflector and assigns the system IP to the edge
- B. SD-WAN Manager, which pushes the full device template that contains the controller addresses
- C. SD-WAN Validator, which authenticates the device and returns the list of controllers it joins
- D. The Plug and Play Connect portal, which builds the permanent DTLS sessions to every controller

**Answer:** C

**Explanation:** The SD-WAN Validator (formerly vBond) is the orchestrator: it is the first point of authentication and tells the edge which Controllers and Manager exist. SD-WAN Manager only pushes configuration after the device is already connected. The SD-WAN Controller reflects OMP routes and policy but does not orchestrate onboarding, and the system IP is configured, not assigned by it. The PnP Connect portal only redirects devices toward the Validator; it does not hold control sessions.

### Question 2 of 10

An edge router has a WAN interface with color mpls and another with color biz-internet. The MPLS provider does not allow traffic toward internet addresses. Why does the edge not try to build a tunnel from its mpls TLOC to a remote biz-internet TLOC that only has a public address?

- A. mpls is a private color and is configured with restrict, so it only forms tunnels to TLOCs of the same color
- B. mpls is a private color, so the router uses the private address and the restrict option blocks the attempt
- C. The SD-WAN Controller filters every TLOC route whose color differs from the color of the TLOC receiving it
- D. Tunnels between different colors are never allowed, regardless of whether restrict is set on the interface

**Answer:** A

**Explanation:** With the restrict keyword on a tunnel interface, the TLOC only forms data plane tunnels to remote TLOCs of the same color, which is the usual design for an MPLS circuit that cannot reach the internet. Private color alone only decides whether private or public addresses are used; it does not block the attempt by itself. Without restrict, tunnels between different colors are allowed by default. The Controller does not filter by color unless a control policy is written to do so.

### Question 3 of 10

A large deployment requires SD-WAN Manager to survive the loss of an entire data center. Which design meets this requirement?

- A. A single Manager cluster that is stretched across both data centers over the WAN links
- B. A Manager backup to an SCP server restored manually to new hardware after a failure
- C. Two independent Manager clusters that each manage half of the WAN Edge routers
- D. Disaster recovery, with an active Manager cluster and a standby cluster at another site

**Answer:** D

**Explanation:** Manager disaster recovery uses an active cluster in one data center and a standby cluster in another, with configuration replicated so the standby can take over. Stretching a cluster across sites is not supported because cluster members need low-latency local connectivity. Splitting edges between independent clusters creates two separate overlays. A manual backup restore meets recovery needs only slowly and with data loss.

### Question 4 of 10

A WAN Edge router shows control connection failures with the error BIDNTVRFD. Which action is most likely to fix the problem?

- A. Change the organization name on the edge so it matches the value on the controllers
- B. Open UDP port 12346 on the branch firewall so DTLS reaches the SD-WAN Validator
- C. Add the edge to the authorized WAN Edge list and send the list to the controllers
- D. Correct the system clock on the edge through NTP so the certificate dates validate

**Answer:** C

**Explanation:** BIDNTVRFD (board ID not verified) means the device's chassis or serial is not in the authorized WAN Edge list, so the fix is to add or sync it and push the list to the controllers. Clock problems cause certificate verification errors. Organization mismatches have their own error code. A blocked port prevents the connection from forming at all and shows timeouts rather than a board ID verification failure.

### Question 5 of 10

A branch runs BGP with a LAN-side core switch in service VPN 10. The routes learned through BGP are not appearing at other sites. What must be configured?

- A. Add the BGP routes to a TLOC list on the SD-WAN Controller
- B. Enable BGP in VPN 0 and peer with the Internet provider
- C. Configure a VPN membership policy for VPN 10 on the Validator
- D. Advertise BGP routes into OMP for VPN 10 on the edge router

**Answer:** D

**Explanation:** OMP advertises connected and static routes by default, but BGP-learned routes must be explicitly advertised (redistributed) into OMP for the service VPN. BGP in VPN 0 relates to the transport side and does not share LAN routes into the overlay. TLOC lists match transport locators, not prefixes. VPN membership policies are applied by Controllers, not the Validator, and do not inject routes.

### Question 6 of 10

An engineer configures TLOC extension between two routers at a site that use a private MPLS circuit on one router. What must be done on the router that does not own the MPLS circuit?

- A. Configure the mpls color on the neighbor's WAN interface by changing its encapsulation
- B. Enable last-resort-circuit on the router so it only sends traffic toward MPLS on failure
- C. Create a tunnel interface in VPN 0 on the link to the neighbor, using the mpls color
- D. Configure a static route in the service VPN pointing to the neighbor's loopback address

**Answer:** C

**Explanation:** The router that borrows the circuit needs a tunnel interface on its link toward the neighbor with the MPLS color; the owning router configures tloc-extension on that link pointing to its MPLS interface, and the private transport may need routing (for example via the provider) for the extended subnet. Changing encapsulation does not move a color. Last-resort-circuit is unrelated. Service VPN static routes do not create a transport TLOC.

### Question 7 of 10

A company wants all branch-to-branch traffic to pass through two data center hubs instead of direct spoke tunnels, without touching branch configurations. Which approach achieves this with the least effort?

- A. A localized route policy on every branch that rejects all OMP routes from spokes
- B. A centralized data policy on every branch that sets the next hop to the hub LAN
- C. A centralized control policy that hides spoke TLOCs and sets hub TLOCs for routes
- D. An application-aware routing policy that marks all spoke-to-spoke tunnels as SLA failures

**Answer:** C

**Explanation:** A centralized control policy on the Controllers can stop advertising spoke TLOCs to other spokes and set the hub TLOCs as next hops for branch routes, producing hub-and-spoke without changing branches. A data policy with next-hop to the hub LAN is more complex and per-flow. A localized route policy affects BGP/OSPF on the edge, not OMP. App-aware routing chooses among existing tunnels and cannot redirect via hubs when SLA fails on all.

### Question 8 of 10

A shared services VPN 100 must be reachable from VPN 10 and VPN 20, while VPN 10 and VPN 20 remain isolated from each other. Which approach implements this centrally across sites?

- A. A data policy with set vpn 100 on every edge for all destination addresses
- B. A centralized control policy that exports routes between VPN 100 and each user VPN
- C. A VPN membership policy that adds VPN 100 as a member of VPN 10 and 20
- D. Merging VPN 10 and VPN 20 into VPN 100 and using ACLs to isolate the two user groups

**Answer:** B

**Explanation:** Route leaking (extranet) between VPNs is done with a centralized control policy that exports routes from the shared services VPN to the user VPNs and vice versa, without leaking VPN 10 and VPN 20 to each other. A data policy that sets VPN 100 for all destinations breaks other traffic. Merging VPNs removes segmentation. VPN membership controls participation, not route leaking.

### Question 9 of 10

Branches must send internet-bound traffic to a cloud security provider for full proxy and firewall services, with automatic tunnel creation and health monitoring. Which feature meets this requirement?

- A. TLOC extension from each branch to a router in the provider data center
- B. Cloud OnRamp for SaaS with gateway sites placed in the provider network
- C. Secure Internet Gateway with automatic IPsec tunnels and trackers
- D. Service insertion with a firewall advertised from the data center hub

**Answer:** C

**Explanation:** SIG integration builds tunnels (automatically for Umbrella and Zscaler) to the cloud security provider and uses trackers to monitor them, with traffic steered to the SIG service. Cloud OnRamp for SaaS optimizes paths to SaaS but does not provide security services. Data center service insertion backhauls traffic to an on-premises firewall. TLOC extension cannot reach a provider network.

### Question 10 of 10

What is the relationship between events and alarms in SD-WAN Manager?

- A. Events are summaries of alarms older than one day
- B. Alarms are only raised by the Validator, while events come from the edges
- C. Events are configuration changes, while alarms are performance statistics
- D. Alarms are built from one or more related events and carry a severity

**Answer:** D

**Explanation:** Devices send events (such as an interface or BFD state change), and the Manager correlates related events into alarms with a severity such as critical or major. Events are not summaries of old alarms. Any device can trigger events that become alarms. Configuration changes appear in the audit log, and statistics are separate from both.

Ready for a timed run? Take the free 15-question 300-415 mini exam: https://devopscodelab.com/app/exams/cisco-300-415/mini/

DevOpsCode Lab is not affiliated with Cisco. 300-415 and related names are trademarks of their owners. We write every question ourselves; these are not real exam questions.
