300-415
Free 300-415 practice questions
10 questions from our 300-415 practice tests, each with the correct answer and a written explanation. Read them with the answers shown, or switch to quiz mode and answer first.
Question 1 of 10, Architecture
A new branch WAN Edge router powers up and must learn which SD-WAN Controllers and which SD-WAN Manager it should connect to. Which component performs this initial authentication and hands out the controller information?
- ASD-WAN Controller, which acts as the OMP route reflector and assigns the system IP to the edge
- BSD-WAN Manager, which pushes the full device template that contains the controller addresses
- CSD-WAN Validator, which authenticates the device and returns the list of controllers it joins Correct answer
- DThe Plug and Play Connect portal, which builds the permanent DTLS sessions to every controller
Answer and explanation: The SD-WAN Validator (formerly vBond) is the orchestrator: it is the first point of authentication and tells the edge which Controllers and Manager exist. SD-WAN Manager only pushes configuration after the device is already connected. The SD-WAN Controller reflects OMP routes and policy but does not orchestrate onboarding, and the system IP is configured, not assigned by it. The PnP Connect portal only redirects devices toward the Validator; it does not hold control sessions.
Question 2 of 10, Architecture
An edge router has a WAN interface with color mpls and another with color biz-internet. The MPLS provider does not allow traffic toward internet addresses. Why does the edge not try to build a tunnel from its mpls TLOC to a remote biz-internet TLOC that only has a public address?
- Ampls is a private color and is configured with restrict, so it only forms tunnels to TLOCs of the same color Correct answer
- Bmpls is a private color, so the router uses the private address and the restrict option blocks the attempt
- CThe SD-WAN Controller filters every TLOC route whose color differs from the color of the TLOC receiving it
- DTunnels between different colors are never allowed, regardless of whether restrict is set on the interface
Answer and explanation: With the restrict keyword on a tunnel interface, the TLOC only forms data plane tunnels to remote TLOCs of the same color, which is the usual design for an MPLS circuit that cannot reach the internet. Private color alone only decides whether private or public addresses are used; it does not block the attempt by itself. Without restrict, tunnels between different colors are allowed by default. The Controller does not filter by color unless a control policy is written to do so.
Question 3 of 10, Controller Deployment
A large deployment requires SD-WAN Manager to survive the loss of an entire data center. Which design meets this requirement?
- AA single Manager cluster that is stretched across both data centers over the WAN links
- BA Manager backup to an SCP server restored manually to new hardware after a failure
- CTwo independent Manager clusters that each manage half of the WAN Edge routers
- DDisaster recovery, with an active Manager cluster and a standby cluster at another site Correct answer
Answer and explanation: Manager disaster recovery uses an active cluster in one data center and a standby cluster in another, with configuration replicated so the standby can take over. Stretching a cluster across sites is not supported because cluster members need low-latency local connectivity. Splitting edges between independent clusters creates two separate overlays. A manual backup restore meets recovery needs only slowly and with data loss.
Question 4 of 10, Controller Deployment
A WAN Edge router shows control connection failures with the error BIDNTVRFD. Which action is most likely to fix the problem?
- AChange the organization name on the edge so it matches the value on the controllers
- BOpen UDP port 12346 on the branch firewall so DTLS reaches the SD-WAN Validator
- CAdd the edge to the authorized WAN Edge list and send the list to the controllers Correct answer
- DCorrect the system clock on the edge through NTP so the certificate dates validate
Answer and explanation: BIDNTVRFD (board ID not verified) means the device's chassis or serial is not in the authorized WAN Edge list, so the fix is to add or sync it and push the list to the controllers. Clock problems cause certificate verification errors. Organization mismatches have their own error code. A blocked port prevents the connection from forming at all and shows timeouts rather than a board ID verification failure.
Question 5 of 10, Router Deployment
A branch runs BGP with a LAN-side core switch in service VPN 10. The routes learned through BGP are not appearing at other sites. What must be configured?
- AAdd the BGP routes to a TLOC list on the SD-WAN Controller
- BEnable BGP in VPN 0 and peer with the Internet provider
- CConfigure a VPN membership policy for VPN 10 on the Validator
- DAdvertise BGP routes into OMP for VPN 10 on the edge router Correct answer
Answer and explanation: OMP advertises connected and static routes by default, but BGP-learned routes must be explicitly advertised (redistributed) into OMP for the service VPN. BGP in VPN 0 relates to the transport side and does not share LAN routes into the overlay. TLOC lists match transport locators, not prefixes. VPN membership policies are applied by Controllers, not the Validator, and do not inject routes.
Question 6 of 10, Router Deployment
An engineer configures TLOC extension between two routers at a site that use a private MPLS circuit on one router. What must be done on the router that does not own the MPLS circuit?
- AConfigure the mpls color on the neighbor's WAN interface by changing its encapsulation
- BEnable last-resort-circuit on the router so it only sends traffic toward MPLS on failure
- CCreate a tunnel interface in VPN 0 on the link to the neighbor, using the mpls color Correct answer
- DConfigure a static route in the service VPN pointing to the neighbor's loopback address
Answer and explanation: The router that borrows the circuit needs a tunnel interface on its link toward the neighbor with the MPLS color; the owning router configures tloc-extension on that link pointing to its MPLS interface, and the private transport may need routing (for example via the provider) for the extended subnet. Changing encapsulation does not move a color. Last-resort-circuit is unrelated. Service VPN static routes do not create a transport TLOC.
Question 7 of 10, Policies
A company wants all branch-to-branch traffic to pass through two data center hubs instead of direct spoke tunnels, without touching branch configurations. Which approach achieves this with the least effort?
- AA localized route policy on every branch that rejects all OMP routes from spokes
- BA centralized data policy on every branch that sets the next hop to the hub LAN
- CA centralized control policy that hides spoke TLOCs and sets hub TLOCs for routes Correct answer
- DAn application-aware routing policy that marks all spoke-to-spoke tunnels as SLA failures
Answer and explanation: A centralized control policy on the Controllers can stop advertising spoke TLOCs to other spokes and set the hub TLOCs as next hops for branch routes, producing hub-and-spoke without changing branches. A data policy with next-hop to the hub LAN is more complex and per-flow. A localized route policy affects BGP/OSPF on the edge, not OMP. App-aware routing chooses among existing tunnels and cannot redirect via hubs when SLA fails on all.
Question 8 of 10, Policies
A shared services VPN 100 must be reachable from VPN 10 and VPN 20, while VPN 10 and VPN 20 remain isolated from each other. Which approach implements this centrally across sites?
- AA data policy with set vpn 100 on every edge for all destination addresses
- BA centralized control policy that exports routes between VPN 100 and each user VPN Correct answer
- CA VPN membership policy that adds VPN 100 as a member of VPN 10 and 20
- DMerging VPN 10 and VPN 20 into VPN 100 and using ACLs to isolate the two user groups
Answer and explanation: Route leaking (extranet) between VPNs is done with a centralized control policy that exports routes from the shared services VPN to the user VPNs and vice versa, without leaking VPN 10 and VPN 20 to each other. A data policy that sets VPN 100 for all destinations breaks other traffic. Merging VPNs removes segmentation. VPN membership controls participation, not route leaking.
Question 9 of 10, Security and Quality of Service
Branches must send internet-bound traffic to a cloud security provider for full proxy and firewall services, with automatic tunnel creation and health monitoring. Which feature meets this requirement?
- ATLOC extension from each branch to a router in the provider data center
- BCloud OnRamp for SaaS with gateway sites placed in the provider network
- CSecure Internet Gateway with automatic IPsec tunnels and trackers Correct answer
- DService insertion with a firewall advertised from the data center hub
Answer and explanation: SIG integration builds tunnels (automatically for Umbrella and Zscaler) to the cloud security provider and uses trackers to monitor them, with traffic steered to the SIG service. Cloud OnRamp for SaaS optimizes paths to SaaS but does not provide security services. Data center service insertion backhauls traffic to an on-premises firewall. TLOC extension cannot reach a provider network.
Question 10 of 10, Management and Operations
What is the relationship between events and alarms in SD-WAN Manager?
- AEvents are summaries of alarms older than one day
- BAlarms are only raised by the Validator, while events come from the edges
- CEvents are configuration changes, while alarms are performance statistics
- DAlarms are built from one or more related events and carry a severity Correct answer
Answer and explanation: Devices send events (such as an interface or BFD state change), and the Manager correlates related events into alarms with a severity such as critical or major. Events are not summaries of old alarms. Any device can trigger events that become alarms. Configuration changes appear in the audit log, and statistics are separate from both.