300-715

Free 300-715 practice questions

10 questions from our 300-715 practice tests, each with the correct answer and a written explanation. Read them with the answers shown, or switch to quiz mode and answer first.

Back to the 300-715 practice exams

Question 1 of 10, Architecture and Deployment. Choose 2.

Which two statements about Cisco ISE persona placement are correct? (Choose two.)

  1. AA node running the pxGrid persona can never also run the Policy Service persona
  2. BThe Monitoring persona must be enabled on every PSN to collect its local logs
  3. CA deployment can include at most two nodes running the Monitoring persona Correct answer
  4. DThe Administration persona must run alone on a dedicated node in every deployment
  5. EThe Policy Service persona can run on the same node as the Administration persona Correct answer

Answer and explanation: ISE supports a primary and a secondary MnT, so at most two Monitoring nodes, and small deployments routinely run Administration, Monitoring and Policy Service on the same nodes. Dedicated PANs are a large-deployment choice rather than a requirement, pxGrid can share a node with Policy Service, and PSNs send their logs to the MnT nodes instead of running Monitoring themselves.

Question 2 of 10, Policy Enforcement

Which Catalyst switch interface command enables MAC Authentication Bypass on an access port?

  1. Amab Correct answer
  2. Baccess-session port-control auto
  3. Cdot1x pae authenticator
  4. Dauthentication host-mode multi-auth

Answer and explanation: The interface command mab enables MAC Authentication Bypass so the switch sends the endpoint MAC address to ISE as the identity. The dot1x pae authenticator command enables the 802.1X authenticator role, access-session port-control auto turns on port-based authentication control, and the host-mode command defines how many endpoints may authenticate on the port.

Question 3 of 10, Policy Enforcement

An IP phone and a PC daisy-chained behind it must both authenticate on the same switch port, with the phone in the voice VLAN and the PC in the data VLAN. No additional devices are allowed. Which host mode should be configured?

  1. AMulti-host mode
  2. BSingle-host mode
  3. CMulti-authentication mode
  4. DMulti-domain mode Correct answer

Answer and explanation: Multi-domain authentication allows exactly one device in the voice domain and one in the data domain, each authenticated separately. Single-host allows only one endpoint, multi-host lets every device through after the first one authenticates, and multi-auth would allow several data devices, which violates the requirement that no additional devices be allowed.

Question 4 of 10, Policy Enforcement

Corporate Windows laptops must be granted full access only if both the machine and the logged-in user authenticate successfully in the same session. Which approach meets this requirement MOST reliably?

  1. AEAP chaining with TEAP so machine and user credentials are validated in one session Correct answer
  2. BMachine Access Restriction, which caches a successful machine login by MAC address
  3. CTwo authorization rules, one for domain computers and one for domain users, in any order
  4. DPEAP-MSCHAPv2 with the supplicant set to authenticate as user or computer

Answer and explanation: TEAP (or EAP-FAST with EAP chaining) carries both machine and user authentication in a single exchange, so ISE can match a condition that requires both results. Machine Access Restriction depends on a cached MAC entry that can expire or be lost, separate rules authorize either identity alone, and user-or-computer mode only presents one identity at a time.

Question 5 of 10, Web Auth and Guest Services

A guest logs in successfully but receives the same restricted access as before. Live Logs show the portal login but no subsequent authorization. What is the MOST likely issue?

  1. AThe NAD did not receive or process the CoA after the portal login Correct answer
  2. BThe guest portal certificate is expired
  3. CThe guest account was created with the wrong guest type by the sponsor who set it up
  4. DThe redirect ACL denies DNS traffic

Answer and explanation: After portal login ISE sends a CoA so the NAD reauthenticates the session; without a new authorization in Live Logs the CoA was not received or processed. A wrong guest type would still produce a new authorization, an expired certificate would show a browser warning before login, and blocked DNS would prevent the portal from loading at all.

Question 6 of 10, Web Auth and Guest Services

Guests on a Catalyst 9800 controller log in successfully on the ISE portal but stay in the redirected state. Live Logs show that ISE sent a CoA and that it timed out. What is the MOST likely cause?

  1. AThe redirect ACL denies traffic to the PSNs, which stops the portal page from loading
  2. BThe guest type limits each guest to a single device
  3. CThe PSN portal certificate is self-signed, so the browser blocks the login request
  4. DA firewall between the PSN and the controller is blocking CoA on UDP port 1700 Correct answer

Answer and explanation: A CoA that times out means the controller never received or answered it, and a firewall blocking UDP 1700 (Cisco's default CoA port) between the PSN and the controller is the classic cause. The redirect ACL denying PSN traffic is correct, because deny means bypass redirection. A device limit or an untrusted certificate would stop the login itself, but here the login succeeded and only the CoA failed.

Question 7 of 10, Profiler

A profiling policy for a medical device has a minimum certainty factor of 30. The only condition the devices match is the MAC OUI condition, which adds 10. What happens?

  1. AIt does not match, because its total certainty is below the minimum Correct answer
  2. BThe device is placed in the policy's parent profile with a certainty factor of 30
  3. CThe device matches the policy, because any matched condition is enough
  4. DThe device matches the policy only after an NMAP scan raises the total

Answer and explanation: An endpoint is assigned a policy only when the sum of its matched condition certainty factors reaches the policy's minimum, so a total of 10 is not enough and the endpoint falls back to a parent or Unknown profile. A single match is not automatically sufficient, NMAP only helps if a condition depends on scan results, and the parent profile is evaluated with its own conditions rather than inheriting a value of 30.

Question 8 of 10, BYOD

An administrator must immediately invalidate one BYOD certificate issued by the ISE internal CA, without waiting for the user to act. OCSP checking is already enabled for EAP-TLS. What should the administrator do?

  1. ARevoke the certificate on the ISE CA Issued Certificates page Correct answer
  2. BLower the certificate template validity so the certificate expires sooner
  3. CMark the device as lost on the user's behalf in the My Devices portal
  4. DDelete the endpoint from Context Visibility, which voids every certificate it holds

Answer and explanation: Administrators can revoke an individual certificate from the Issued Certificates list of the ISE CA, and with OCSP checking the device is rejected at its next authentication. Deleting an endpoint record is not a documented way to revoke its certificate, changing the template only affects certificates issued later, and marking a device as lost blocks it without revoking the certificate.

Question 9 of 10, Endpoint Compliance

A posture deployment uses redirection to discover the PSN, but some endpoints reconnect to a network where redirection is not configured, and posture stalls in Unknown. Which configuration helps the agent find ISE without redirection?

  1. AThe call home list in the ISE posture profile, listing PSNs to contact Correct answer
  2. BThe DHCP probe on all PSNs, so ISE contacts the agent directly
  3. CA posture lease of seven days so the agent does not need to discover ISE
  4. DThe default posture status set to Compliant for all Windows endpoints

Answer and explanation: The call home list in the ISE posture profile gives the agent PSN addresses to contact directly, which supports redirectionless posture. A posture lease only skips assessments when status is already known, the DHCP probe is for profiling, and setting a default status of Compliant would skip the assessment instead of helping the agent reach ISE.

Question 10 of 10, Network Access Device Administration

An IOS router is configured with 'aaa authentication login default group tacacs+ local'. A user enters a wrong password and ISE rejects the login. What happens?

  1. AThe login fails, because local is only tried when the TACACS+ servers do not respond Correct answer
  2. BThe router falls back to the enable password configured on the device
  3. CThe router retries the request against every TACACS+ server in the group
  4. DThe router tries the local user database next and logs the user in if it matches

Answer and explanation: Method lists fall back to the next method only when the current one returns an error, such as no server response, not when a server rejects the credentials. A rejection ends the attempt, so the local database is not consulted, other servers in the group are not tried for a reject, and the enable password is not used as a login fallback here.