NSE4_FGT_AD-7.6

NSE4_FGT_AD-7.6 FortiOS 7.6 Administrator practice exams

265 questions in 5 timed practice tests. Each test has about 55 questions and a 100-minute limit. The pass mark is 70%. Results are split across the 5 exam domains.

Exam at a glance

NSE4_FGT_AD-7.6 practice exam settings
Practice tests 5
Questions in total 265
Questions per test About 55
Time limit per test 100 minutes
Pass mark 70%
Question types Single answer and multiple answer (32 multiple-answer questions)
Level Associate
Category Security

These are the settings of our practice tests. Check the official Fortinet exam page for the current exam format before you book.

Domains and weights

NSE4_FGT_AD-7.6 exam domains, weights and question counts
Domain Weight Weight bar Questions in our bank
Deployment and System Configuration 25% 66
Firewall Policies and Authentication 25% 66
Content Inspection 20% 53
Routing 15% 40
VPN 15% 40

Sample questions

Question 1 of 3

A super_admin account must be usable only from the 10.10.50.0/24 management subnet. Users on other subnets can still reach the HTTPS login page on the same interface. What should the administrator configure?

  1. A Trusted hosts on the administrator account, set to 10.10.50.0/24 (correct answer)
  2. B An admin profile with all permission groups set to read-only for sources outside 10.10.50.0/24
  3. C A firewall policy from the management subnet to the FortiGate interface address with action ACCEPT
  4. D A DoS policy on the management interface that limits HTTPS sessions from other subnets to zero
Why: Trusted hosts are configured per administrator and limit the source addresses from which that account can log in; when any trusted host is set, logins from other sources are refused. Firewall policies control traffic passing through FortiGate, not administrative traffic to its own interfaces. Admin profiles control permissions but cannot vary by source address, and a DoS policy limits anomalous rates rather than enforcing a login allow-list.

Question 2 of 3

An administrator wants to make sure that the FortiGate GUI can be reached only through port3, using HTTPS, and never through port1, which faces the internet. Where is this controlled?

  1. A The admin profile attached to the account, by giving the System permission group read-write access
  2. B A local-in policy that is generated automatically when HTTPS is selected in the admin profile
  3. C The Trusted Hosts list of the admin account, adding the port3 subnet and leaving port1 out of the list
  4. D The Administrative Access settings of each interface, enabling HTTPS on port3 and clearing it on port1 (correct answer)
Why: Management protocols such as HTTPS, SSH, PING and SNMP are enabled per interface in its Administrative Access settings, so enabling HTTPS only on port3 is the direct control. Trusted hosts restrict source IP addresses, not the interface on which the GUI listens. Admin profiles define which configuration areas an administrator may change, and selecting a protocol in a profile does not generate local-in policies.

Question 3 of 3

Two FortiGate devices form an FGCP HA cluster with override disabled. Both have the same number of monitored interfaces up, and the HA uptime difference between them is greater than the margin. Which factor decides which unit becomes primary?

  1. A The unit with the higher HA uptime (correct answer)
  2. B The unit with the higher serial number
  3. C The unit with the higher device priority setting
  4. D The unit that has more active sessions in its table
Why: With override disabled, FGCP compares connected monitored interfaces first, then HA uptime, then device priority, then serial number. Because uptime differs by more than the margin, the unit with the higher HA uptime wins before priority is even considered. Priority only decides first when override is enabled, the serial number is the final tie-breaker, and session count is not an election criterion.

What your score report looks like

Example attempt, NSE4_FGT_AD-7.6 practice test 3

79%

Passed
Pass mark 70%

Score by exam domain
DomainWeightYour score%
Deployment and System Configuration 25%
88
Firewall Policies and Authentication 25%
81
Content Inspection 20%
76
Routing 15%
58
VPN 15%
84

Study next: Routing. It is below the pass mark and carries 15% of the exam.

Domains and pass mark from our NSE4_FGT_AD-7.6 practice tests. Scores are an example attempt.

Study plans

Two weeks

  1. Day 1: take practice test 1 in exam mode to get a baseline.
  2. Days 2 to 5: domain mode on Deployment and System Configuration and Firewall Policies and Authentication, the two most heavily weighted domains.
  3. Day 6: practice test 2 in exam mode, then the mistakes quiz.
  4. Days 7 to 12: practice tests 3 to 5, one every other day, each followed by its mistakes quiz.
  5. Days 13 and 14: final mode. Book the exam when your readiness stays above the pass mark.

Four weeks

  1. Week 1: one practice test in practice mode, reading every explanation. Note your two lowest domains.
  2. Week 2: domain mode on those two domains, then a second practice test in exam mode.
  3. Week 3: practice tests 3 and 4 in exam mode, with the mistakes and flagged quizzes after each.
  4. Week 4: practice test 5 and final mode until your readiness holds above the pass mark.

Questions about the NSE4_FGT_AD-7.6 practice exams

Are these real NSE4_FGT_AD-7.6 exam questions?
No. We write every question ourselves and map it to the published NSE4_FGT_AD-7.6 exam objectives. We do not use leaked or recalled questions.
Do the time limit and pass mark match the official exam?
They match the settings of our practice tests. Exam providers change their format from time to time, so check the official exam page before you book.
Can I try it before I pay?
Yes. The free mini exam has 15 questions with full explanations and needs no account.
How long do I keep access?
A single-exam purchase gives you 12 months of access. All-Access includes this exam for as long as your subscription runs.
What happens after I finish a test?
You get a score, a pass or fail against the pass mark, a score per domain and every answer with its explanation.

Last updated November 2026. Written and reviewed by the DevOpsCode Lab team.

DevOpsCode Lab is not affiliated with Fortinet. NSE4_FGT_AD-7.6 and related names are trademarks of their owners.

Related exams
Exam Vendor Level Questions Minutes Price
FCP_FAZ_AN-7.6FCP_FAZ_AN-7.6 FortiAnalyzer 7.6 Analyst Fortinet Professional 200 65 $14.99
NSE7_FSN_AR-7.6NSE7_FSN_AR-7.6 Secure Networking Architect Fortinet Professional 225 70 $14.99
NSE5_FSW_AD-7.6NSE5_FSW_AD-7.6 FortiSwitch 7.6 Administrator Fortinet Associate 200 70 $12.99
NSE6_FMG_AD-7.6NSE6_FMG_AD-7.6 FortiManager 7.6 Administrator Fortinet Associate 200 70 $12.99
100-160Cisco CCST Cybersecurity 100-160 Cisco Foundational 251 50 $9.99
CCCC Certified in Cybersecurity ISC2 Foundational 376 120 $9.99