200-301

Cisco CCNA 200-301 v1.1 practice exams

291 questions in 5 timed practice tests. Each test has about 60 questions and a 120-minute limit. The pass mark is 75%. Results are split across the 6 exam domains.

Read the 200-301 study guide: what the exam covers, a 4-week plan and the topics people miss.

Exam at a glance

200-301 practice exam settings
Practice tests 5
Questions in total 291
Questions per test About 60
Time limit per test 120 minutes
Pass mark 75%
Question types Single answer and multiple answer (33 multiple-answer questions)
Level Associate
Category Networking

These are the settings of our practice tests. Check the official Cisco exam page for the current exam format before you book.

Domains and weights

200-301 exam domains, weights and question counts
Domain Weight Weight bar Questions in our bank
Network Fundamentals 20% 58
Network Access 20% 58
IP Connectivity 25% 72
IP Services 10% 29
Security Fundamentals 15% 44
Automation and Programmability 10% 30

Sample questions

Question 1 of 3

A data center team is replacing a three-tier design with a topology in which every leaf switch connects to every spine switch and no two leaf switches connect directly. What is the main benefit of this topology for east-west traffic between servers?

  1. A Spanning tree is required to block redundant leaf-to-spine links for loop prevention
  2. B Any two servers on different leaves are a predictable, equal number of hops apart (correct answer)
  3. C Leaf switches can forward traffic to each other without traversing a spine switch
  4. D The spine layer only carries north-south traffic toward the WAN and the internet
Why: In a spine-leaf fabric each leaf is exactly one spine away from every other leaf, so server-to-server latency is consistent and bandwidth scales by adding spines. The links are typically routed and used with ECMP rather than blocked by spanning tree. Leaves do not connect to each other, so traffic between leaves always crosses a spine, and the spines carry east-west traffic, not only north-south traffic.

Question 2 of 3

The show interfaces output on a switch port shows a steadily increasing count of late collisions, while the connected PC reports no collisions at all. What is the MOST likely cause?

  1. A A duplex mismatch, with the switch side at half duplex and the PC at full duplex (correct answer)
  2. B An EMI source near the cable that corrupts frames and increments CRC counters
  3. C A native VLAN mismatch between the switch port and the network adapter on the PC
  4. D A speed mismatch, with the switch port at 100 Mbps and the PC at 1000 Mbps
Why: Late collisions on one side only are the classic symptom of a duplex mismatch: the half-duplex side detects collisions while the full-duplex side transmits freely. A true speed mismatch normally prevents the link from coming up at all, electrical noise shows up mainly as CRC and input errors, and a native VLAN mismatch is a trunk problem that does not create collisions on an access port.

Question 3 of 3

A switch port connects to a lightweight AP in local mode. How should the switch port normally be configured?

  1. A As an access port in the AP's management VLAN only (correct answer)
  2. B As an EtherChannel member bundled with the controller
  3. C As an 802.1Q trunk carrying every WLAN client VLAN
  4. D As a routed port with no switchport configured
Why: A local-mode AP tunnels all client traffic to the controller in CAPWAP, so its switch port only needs to be an access port in the VLAN where the AP gets its management address. Trunks are typical for FlexConnect APs that switch client VLANs locally or for controller uplinks, a routed port is unnecessary, and EtherChannel is used between the controller and the switch rather than on AP ports.

What your score report looks like

Example attempt, 200-301 practice test 3

78%

Passed
Pass mark 75%

Score by exam domain
DomainWeightYour score%
Network Fundamentals 20%
88
Network Access 20%
81
IP Connectivity 25%
76
IP Services 10%
58
Security Fundamentals 15%
84
Automation and Programmability 10%
72

Study next: IP Services. It is below the pass mark and carries 10% of the exam.

Domains and pass mark from our 200-301 practice tests. Scores are an example attempt.

Study plans

Two weeks

  1. Day 1: take practice test 1 in exam mode to get a baseline.
  2. Days 2 to 5: domain mode on IP Connectivity and Network Fundamentals, the two most heavily weighted domains.
  3. Day 6: practice test 2 in exam mode, then the mistakes quiz.
  4. Days 7 to 12: practice tests 3 to 5, one every other day, each followed by its mistakes quiz.
  5. Days 13 and 14: final mode. Book the exam when your readiness stays above the pass mark.

Four weeks

  1. Week 1: one practice test in practice mode, reading every explanation. Note your two lowest domains.
  2. Week 2: domain mode on those two domains, then a second practice test in exam mode.
  3. Week 3: practice tests 3 and 4 in exam mode, with the mistakes and flagged quizzes after each.
  4. Week 4: practice test 5 and final mode until your readiness holds above the pass mark.

Questions about the 200-301 practice exams

Are these real 200-301 exam questions?
No. We write every question ourselves and map it to the published 200-301 exam objectives. We do not use leaked or recalled questions.
Do the time limit and pass mark match the official exam?
They match the settings of our practice tests. Exam providers change their format from time to time, so check the official exam page before you book.
Can I try it before I pay?
Yes. The free mini exam has 15 questions with full explanations and needs no account.
How long do I keep access?
A single-exam purchase gives you 12 months of access. All-Access includes this exam for as long as your subscription runs.
What happens after I finish a test?
You get a score, a pass or fail against the pass mark, a score per domain and every answer with its explanation.

Last updated November 2026. Written and reviewed by the DevOpsCode Lab team.

DevOpsCode Lab is not affiliated with Cisco. 200-301 and related names are trademarks of their owners.

Related exams
Exam Vendor Level Questions Minutes Price
300-410Cisco ENARSI 300-410 Cisco Professional 300 90 $14.99
300-415300-415 Cisco SD-WAN Solutions Cisco Professional 300 90 $14.99
300-420300-420 Designing Cisco Enterprise Networks Cisco Professional 300 90 $14.99
300-435Cisco ENAUTO 300-435 Cisco Professional 300 90 $14.99
300-620Cisco DCACI 300-620 v1.2 Cisco Professional 300 90 $14.99
300-715Cisco SISE 300-715 Cisco Professional 300 90 $14.99