JN0-352

JNCIS-ENT JN0-352 practice exams

290 questions in 5 timed practice tests. Each test has about 61 questions and a 90-minute limit. The pass mark is 70%. Results are split across the 9 exam domains.

Exam at a glance

JN0-352 practice exam settings
Practice tests 5
Questions in total 290
Questions per test About 61
Time limit per test 90 minutes
Pass mark 70%
Question types Single answer and multiple answer (31 multiple-answer questions)
Level Professional
Category Networking

These are the settings of our practice tests. Check the official Juniper Networks exam page for the current exam format before you book.

Domains and weights

JN0-352 exam domains, weights and question counts
Domain Weight Weight bar Questions in our bank
Layer 2 Switching and VLANs 12% 35
Spanning Tree 11% 32
Layer 2 Security 12% 35
Protocol Independent Routing 12% 35
OSPF 13% 37
IS-IS 10% 29
BGP 13% 38
Tunnels 8% 23
High Availability 9% 26

Sample questions

Question 1 of 3

An ELS switch has VLAN V40 with l3-interface irb.40 configured and an IP address on irb.40. The only interface in V40 is down, and hosts on other VLANs cannot ping the irb.40 address. What explains this?

  1. A IRB addresses only answer pings from hosts in the same VLAN unless a firewall filter permits it
  2. B An IRB interface stays down until at least one Layer 2 interface in its VLAN is up (correct answer)
  3. C IRB interfaces need the VLAN to also be assigned to a virtual-router instance to become active
  4. D irb.40 must use the same unit number as the VLAN ID and the VLAN must be named vlan40
Why: The IRB logical interface is operationally up only when the VLAN it is bound to has at least one active Layer 2 member, so with the only member down the address is not reachable. There is no default filter limiting IRB pings to the same VLAN. No routing instance is required, and while matching the unit number to the VLAN ID is a convention, neither the unit number nor the VLAN name is mandated.

Question 2 of 3

On an RSTP switch, a unidirectional link failure causes an alternate port to stop receiving BPDUs, and the engineer fears it will start forwarding and create a loop. Which configuration addresses this?

  1. A set protocols layer2-control bpdu-block interface ge-0/0/2
  2. B set protocols rstp interface ge-0/0/2 no-root-port and edge
  3. C set protocols rstp interface ge-0/0/2 edge
  4. D set protocols rstp interface ge-0/0/2 bpdu-timeout-action block (correct answer)
Why: Loop protection (bpdu-timeout-action block) keeps a non-designated port in a loop-inconsistent blocking state when BPDUs stop arriving, instead of letting it transition to designated and forward. Root protection reacts to superior BPDUs, not missing ones, and adding edge would make the port forward even faster, and BPDU blocking disables a port that receives BPDUs, which is the wrong reaction for an inter-switch link.

Question 3 of 3

On an ELS switch, users in VLAN EMPLOYEE must only receive DHCP leases from the server on trunk ge-0/0/47, and rogue DHCP servers on access ports must be blocked. Which configuration enables this protection?

  1. A set system services dhcp-local-server group EMPLOYEE interface ge-0/0/47.0
  2. B set protocols dhcp-relay group EMPLOYEE interface ge-0/0/47.0
  3. C set vlans EMPLOYEE forwarding-options dhcp-security (correct answer)
  4. D set vlans EMPLOYEE forwarding-options dhcp-security arp-inspection
Why: Enabling dhcp-security on the VLAN turns on DHCP snooping; on ELS switches trunk ports are trusted by default and access ports untrusted, so server replies arriving on access ports are dropped. DHCP relay forwards client requests to a server in another subnet and gives no snooping protection. The arp-inspection keyword adds DAI on top of snooping but is not the statement that enables snooping by itself, and dhcp-local-server makes the switch a DHCP server.

What your score report looks like

Example attempt, JN0-352 practice test 3

77%

Passed
Pass mark 70%

Score by exam domain
DomainWeightYour score%
Layer 2 Switching and VLANs 12%
88
Spanning Tree 11%
81
Layer 2 Security 12%
76
Protocol Independent Routing 12%
58
OSPF 13%
84
IS-IS 10%
72

Study next: Protocol Independent Routing. It is below the pass mark and carries 12% of the exam.

Domains and pass mark from our JN0-352 practice tests. Scores are an example attempt.

Study plans

Two weeks

  1. Day 1: take practice test 1 in exam mode to get a baseline.
  2. Days 2 to 5: domain mode on OSPF and BGP, the two most heavily weighted domains.
  3. Day 6: practice test 2 in exam mode, then the mistakes quiz.
  4. Days 7 to 12: practice tests 3 to 5, one every other day, each followed by its mistakes quiz.
  5. Days 13 and 14: final mode. Book the exam when your readiness stays above the pass mark.

Four weeks

  1. Week 1: one practice test in practice mode, reading every explanation. Note your two lowest domains.
  2. Week 2: domain mode on those two domains, then a second practice test in exam mode.
  3. Week 3: practice tests 3 and 4 in exam mode, with the mistakes and flagged quizzes after each.
  4. Week 4: practice test 5 and final mode until your readiness holds above the pass mark.

Questions about the JN0-352 practice exams

Are these real JN0-352 exam questions?
No. We write every question ourselves and map it to the published JN0-352 exam objectives. We do not use leaked or recalled questions.
Do the time limit and pass mark match the official exam?
They match the settings of our practice tests. Exam providers change their format from time to time, so check the official exam page before you book.
Can I try it before I pay?
Yes. The free mini exam has 15 questions with full explanations and needs no account.
How long do I keep access?
A single-exam purchase gives you 12 months of access. All-Access includes this exam for as long as your subscription runs.
What happens after I finish a test?
You get a score, a pass or fail against the pass mark, a score per domain and every answer with its explanation.

Last updated November 2026. Written and reviewed by the DevOpsCode Lab team.

DevOpsCode Lab is not affiliated with Juniper Networks. JN0-352 and related names are trademarks of their owners.

Related exams
Exam Vendor Level Questions Minutes Price
JN0-106JNCIA-Junos JN0-106 Juniper Networks Associate 300 90 $12.99
JN0-650JN0-650 Enterprise Routing and Switching Juniper Networks Professional 300 90 $14.99
100-140Cisco CCST IT Support 100-140 Cisco Foundational 225 50 $9.99
100-150Cisco CCST Networking 100-150 Cisco Foundational 226 50 $9.99
200-301Cisco CCNA 200-301 v1.1 Cisco Associate 301 120 $12.99
AZ-700Azure Network Engineer AZ-700 Microsoft Associate 250 100 $12.99