HPE7-A08

HPE7-A08 HPE Network Switching Professional practice exams

366 questions in 5 timed practice tests. Each test has about 75 questions and a 120-minute limit. The pass mark is 65%. Results are split across the 4 exam domains.

Exam at a glance

HPE7-A08 practice exam settings
Practice tests 5
Questions in total 366
Questions per test About 75
Time limit per test 120 minutes
Pass mark 65%
Question types Single answer and multiple answer (34 multiple-answer questions)
Level Professional
Category Networking

These are the settings of our practice tests. Check the official HPE exam page for the current exam format before you book.

Domains and weights

HPE7-A08 exam domains, weights and question counts
Domain Weight Weight bar Questions in our bank
Create the implementation plan for the wired network solution 18% 66
Install and configure the wired network solution 33% 121
Troubleshoot the wired network solution 27% 98
Manage, maintain, optimize, and monitor the wired network solution 22% 81

Sample questions

Question 1 of 3

An engineer is designing a new campus with a CX 6400 VSX pair as the core and CX 6300 VSF stacks at the access layer. The customer wants the smallest possible spanning-tree domain and fast convergence when an access uplink fails. Where should the Layer 2/Layer 3 boundary be placed, and how should the access uplinks be built?

  1. A Route at the core SVIs and connect each stack through a single uplink cable with a second cable in standby
  2. B Route at the core SVIs with active-gateway and use one VSX LAG per stack, spread across members (correct answer)
  3. C Route at each access stack and run OSPF over individual point-to-point uplinks to each core switch
  4. D Route at the core SVIs with VRRP and connect each stack through two separate LAGs blocked by MSTP
Why: With routing at the VSX core using active-gateway and a VSX LAG spread across stack members, every uplink forwards, spanning tree has no blocked loops to converge, and member or link failures only remove a LAG member. Routing at the access layer is a valid design but moves the Layer 3 boundary away from the VSX core the customer chose and requires many more routed links and subnets. Two LAGs blocked by MSTP waste bandwidth and depend on spanning-tree convergence. A single active uplink is a single point of failure until a standby link is brought up.

Question 2 of 3

A university needs to extend the same Layer 2 segments for IoT devices across three buildings while routing all other traffic locally, keep each building in its own failure domain, and apply group-based policy between user roles. The customer manages the campus from HPE Aruba Networking Central. Which approach BEST fits?

  1. A A VSF stack that spans the three buildings so the IoT VLAN exists on one logical switch
  2. B A single MSTP region spanning all three buildings with the IoT VLAN trunked everywhere
  3. C A Central NetConductor EVPN-VXLAN fabric with role-based policy carried in the VXLAN header (correct answer)
  4. D Static VXLAN tunnels between building cores with ACLs applied on every access port
Why: A NetConductor fabric uses EVPN-VXLAN to stretch only the needed segments over a routed underlay, so each building stays its own Layer 3 failure domain, and it carries group policy identifiers in the VXLAN header for role-to-role policy. A campus-wide MSTP region makes the whole campus one Layer 2 failure domain. Static VXLAN lacks a control plane and would need per-port ACLs for policy, which does not scale. A VSF stack across buildings is not a supported campus design and creates one large failure domain.

Question 3 of 3

In an EVPN-VXLAN fabric, leaf switches peer with two spines using iBGP. The spines do not host VTEPs. What must be configured on the spines for leaf routes to reach other leaves?

  1. A The spines must run eBGP to each leaf with the same AS on all leaves and no other changes
  2. B The spines must redistribute EVPN routes into OSPF so leaves learn them
  3. C The spines must act as route reflectors with the leaves as clients in L2VPN EVPN (correct answer)
  4. D The spines must use next-hop-self toward the leaves for every EVPN route
Why: iBGP does not re-advertise routes learned from one iBGP peer to another, so spines must be route reflectors with the leaves configured as route-reflector clients for the L2VPN EVPN family. EVPN routes are not redistributed into OSPF. Setting next-hop-self on spines would make the spines the VXLAN next hop, which breaks the tunnel endpoints. Using eBGP with the same AS on all leaves would cause routes to be rejected by AS-path loop prevention unless extra settings are used, and it is a different design from the stated iBGP fabric.

What your score report looks like

Example attempt, HPE7-A08 practice test 3

76%

Passed
Pass mark 65%

Score by exam domain
DomainWeightYour score%
Create the implementation plan for the wired network solution 18%
88
Install and configure the wired network solution 33%
81
Troubleshoot the wired network solution 27%
76
Manage, maintain, optimize, and monitor the wired network solution 22%
58

Study next: Manage, maintain, optimize, and monitor the wired network solution. It is below the pass mark and carries 22% of the exam.

Domains and pass mark from our HPE7-A08 practice tests. Scores are an example attempt.

Study plans

Two weeks

  1. Day 1: take practice test 1 in exam mode to get a baseline.
  2. Days 2 to 5: domain mode on Install and configure the wired network solution and Troubleshoot the wired network solution, the two most heavily weighted domains.
  3. Day 6: practice test 2 in exam mode, then the mistakes quiz.
  4. Days 7 to 12: practice tests 3 to 5, one every other day, each followed by its mistakes quiz.
  5. Days 13 and 14: final mode. Book the exam when your readiness stays above the pass mark.

Four weeks

  1. Week 1: one practice test in practice mode, reading every explanation. Note your two lowest domains.
  2. Week 2: domain mode on those two domains, then a second practice test in exam mode.
  3. Week 3: practice tests 3 and 4 in exam mode, with the mistakes and flagged quizzes after each.
  4. Week 4: practice test 5 and final mode until your readiness holds above the pass mark.

Questions about the HPE7-A08 practice exams

Are these real HPE7-A08 exam questions?
No. We write every question ourselves and map it to the published HPE7-A08 exam objectives. We do not use leaked or recalled questions.
Do the time limit and pass mark match the official exam?
They match the settings of our practice tests. Exam providers change their format from time to time, so check the official exam page before you book.
Can I try it before I pay?
Yes. The free mini exam has 15 questions with full explanations and needs no account.
How long do I keep access?
A single-exam purchase gives you 12 months of access. All-Access includes this exam for as long as your subscription runs.
What happens after I finish a test?
You get a score, a pass or fail against the pass mark, a score per domain and every answer with its explanation.

Last updated November 2026. Written and reviewed by the DevOpsCode Lab team.

DevOpsCode Lab is not affiliated with HPE. HPE7-A08 and related names are trademarks of their owners.

Related exams
Exam Vendor Level Questions Minutes Price
HPE6-A86HPE6-A86 HPE Network Switching Associate HPE Associate 300 90 $12.99
HPE7-A01HPE7-A01 HPE Network Campus Access Pro HPE Professional 375 120 $14.99
100-140Cisco CCST IT Support 100-140 Cisco Foundational 225 50 $9.99
100-150Cisco CCST Networking 100-150 Cisco Foundational 226 50 $9.99
200-301Cisco CCNA 200-301 v1.1 Cisco Associate 301 120 $12.99
AZ-700Azure Network Engineer AZ-700 Microsoft Associate 250 100 $12.99