HPE7-A01

HPE7-A01 HPE Network Campus Access Pro practice exams

365 questions in 5 timed practice tests. Each test has about 75 questions and a 120-minute limit. The pass mark is 68%. Results are split across the 5 exam domains.

Exam at a glance

HPE7-A01 practice exam settings
Practice tests 5
Questions in total 365
Questions per test About 75
Time limit per test 120 minutes
Pass mark 68%
Question types Single answer and multiple answer (38 multiple-answer questions)
Level Professional
Category Networking

These are the settings of our practice tests. Check the official HPE exam page for the current exam format before you book.

Domains and weights

HPE7-A01 exam domains, weights and question counts
Domain Weight Weight bar Questions in our bank
Plan the Solution 21% 77
Configure the Solution 26% 95
Operate the Solution 15% 54
Troubleshoot the Solution 24% 87
Optimize the Solution 14% 52

Sample questions

Question 1 of 3

An architect's high-level design states that all IoT devices will be placed in one VLAN spanning every building. The customer has thousands of IoT devices and requires that a compromised device cannot reach devices of another type. Which adjustment should the engineer propose for the low-level design?

  1. A Keep one IoT VLAN but increase the subnet size so every building can share the same DHCP scope
  2. B Use role-based policies so each IoT device type gets its own role with rules that block peer traffic (correct answer)
  3. C Place every IoT device in the existing guest VLAN, which already has client isolation enabled on the WLAN
  4. D Create one /24 subnet per building and route between them on the core without additional filtering
Why: Role-based policy, assigned per device type through ClearPass or the local profiling, enforces micro-segmentation regardless of VLAN, which meets the requirement to block cross-type traffic. A larger subnet increases the broadcast domain, per-building subnets routed without filtering still allow cross-type reachability, and moving IoT into the guest VLAN mixes them with visitors and does not cover wired devices.

Question 2 of 3

A retail chain will onboard 400 new AOS-CX switches and APs to HPE Aruba Networking Central using zero-touch provisioning. Which preparation step must be completed before the devices are shipped to stores so that they land in the correct configuration group automatically?

  1. A Add the devices to the HPE GreenLake inventory, assign subscriptions, and pre-assign them to the Central group (correct answer)
  2. B Upload the store configuration templates to an internal TFTP server and point each device to it with DHCP option 66
  3. C Stage every device in a lab, apply the store configuration over the console, and save it to the startup configuration
  4. D Create a DHCP reservation on each store's router that hands out the Central URL as DHCP option 43 to every device
Why: Zero-touch provisioning to Central relies on the devices being in the GreenLake device inventory with a valid subscription and assigned to the Central application and group, so they inherit configuration when they first call home. Lab staging over the console defeats the purpose of ZTP, and option 43 or TFTP/option 66 methods are on-premises provisioning techniques that do not place devices into a Central group.

Question 3 of 3

An engineer is configuring an AOS-CX VSX pair as the default gateway for VLAN 20. Both switches must forward traffic for hosts in VLAN 20 at the same time, and hosts must not need to relearn their gateway MAC address when one member fails. Which feature should be configured on the VLAN 20 interface of both members?

  1. A active-gateway with the same virtual IP address and virtual MAC address (correct answer)
  2. B ip helper-address pointing to both members' physical SVI addresses
  3. C A static ARP entry for the gateway on every host in the subnet
  4. D VRRP on both members with a higher priority configured on the VSX primary member
Why: VSX active-gateway gives both members the same virtual IP and virtual MAC so each can route traffic for the subnet locally (active-active) and failure is transparent to hosts. VRRP elects a single master per group, so only one member forwards as the gateway. An IP helper address relays DHCP and does not provide gateway redundancy, and static ARP entries on hosts are unmanageable and do not give active-active forwarding.

What your score report looks like

Example attempt, HPE7-A01 practice test 3

77%

Passed
Pass mark 68%

Score by exam domain
DomainWeightYour score%
Plan the Solution 21%
88
Configure the Solution 26%
81
Operate the Solution 15%
76
Troubleshoot the Solution 24%
58
Optimize the Solution 14%
84

Study next: Troubleshoot the Solution. It is below the pass mark and carries 24% of the exam.

Domains and pass mark from our HPE7-A01 practice tests. Scores are an example attempt.

Study plans

Two weeks

  1. Day 1: take practice test 1 in exam mode to get a baseline.
  2. Days 2 to 5: domain mode on Configure the Solution and Troubleshoot the Solution, the two most heavily weighted domains.
  3. Day 6: practice test 2 in exam mode, then the mistakes quiz.
  4. Days 7 to 12: practice tests 3 to 5, one every other day, each followed by its mistakes quiz.
  5. Days 13 and 14: final mode. Book the exam when your readiness stays above the pass mark.

Four weeks

  1. Week 1: one practice test in practice mode, reading every explanation. Note your two lowest domains.
  2. Week 2: domain mode on those two domains, then a second practice test in exam mode.
  3. Week 3: practice tests 3 and 4 in exam mode, with the mistakes and flagged quizzes after each.
  4. Week 4: practice test 5 and final mode until your readiness holds above the pass mark.

Questions about the HPE7-A01 practice exams

Are these real HPE7-A01 exam questions?
No. We write every question ourselves and map it to the published HPE7-A01 exam objectives. We do not use leaked or recalled questions.
Do the time limit and pass mark match the official exam?
They match the settings of our practice tests. Exam providers change their format from time to time, so check the official exam page before you book.
Can I try it before I pay?
Yes. The free mini exam has 15 questions with full explanations and needs no account.
How long do I keep access?
A single-exam purchase gives you 12 months of access. All-Access includes this exam for as long as your subscription runs.
What happens after I finish a test?
You get a score, a pass or fail against the pass mark, a score per domain and every answer with its explanation.

Last updated November 2026. Written and reviewed by the DevOpsCode Lab team.

DevOpsCode Lab is not affiliated with HPE. HPE7-A01 and related names are trademarks of their owners.

Related exams
Exam Vendor Level Questions Minutes Price
HPE6-A86HPE6-A86 HPE Network Switching Associate HPE Associate 300 90 $12.99
HPE7-A08HPE7-A08 HPE Network Switching Professional HPE Professional 376 120 $14.99
100-140Cisco CCST IT Support 100-140 Cisco Foundational 225 50 $9.99
100-150Cisco CCST Networking 100-150 Cisco Foundational 226 50 $9.99
200-301Cisco CCNA 200-301 v1.1 Cisco Associate 301 120 $12.99
AZ-700Azure Network Engineer AZ-700 Microsoft Associate 250 100 $12.99